Posted on: 2004/8/6 20:57
Re: wfsection - which html document to use?
Your website is still down for me, even when I click the link you posted.
This is an option. This is not a must. If you choose a html document here than that document will be displayed instead of the stuff you would usually type into the 'maintext' textfield a bit below this option.
Please note that you have to check 'Connect Page' for this to work.
The 'Connect Page' is only a option on the article creation form. My question is reagarding creating a Section, not an article.
I created a test section and a test article within that section. When creating the Section
, there is a option to "Select HTML Document". I chose one from the list.
I chose to have the section display in the main menu. I then went to the home page and clicked wfsection from the main menu. THis caused a link to my test section to appear in the main menu under wfsection. On the wfsection page I see my section listed and the test article listed. If I click on the link to the section
from the main menu or page, I get a blank white page. After reading your post, I went back and modified the section and changed the "HTML Document" to "----------" from the drop menu. I went back and checked, but it was still a blank white page. Went to modify again and the "HTML Document" I had intially selected, was selected again. So I started over and this time selected "---------" as the "HTML Document" from the beginning. Still resulted in a blank white page.
Am I required to make an default html document for each section and upload it? Selecting any of the choices from the drop menu result in a blank white page.