Hi,
I have implemented the myiframe module. I can set the width as 100% but I can't use the same value for height, because it shows only a small portion of the framed page (about 100px). I have tried all combinations with the scrolling bar option (yes, auto etc.) but it works only if I set the height in pixels e.g. 1000px. This causes an aesthetic problem because when the page is smaller than 1000px there is an unused space at the end of the page. If the page is bigger than 1000px, then scrolling bars appear.
Is there any way of setting the height value to 100%?
Any help is appreciated.

Thanks
Themis

I'm not sure it's possible to adjust an ifram to calculate heigh from content. I think it's designed only to calculate from percentage or pixel height from the page it's in.