1
Mithrandir
2nd XOOPS 2.2.3 RC2 Snapshot Release

After the rather successful snapshot release of XOOPS 2.2.3 RC2, we are almost ready for a public 2.2.3 RC2 (Still an RC) but want your final input before the launch.

Therefore we release a 2nd snapshot of RC2:
XOOPS 2.2.3 RC2 Snapshot2.tar.gz
XOOPS 2.2.3 RC2 Snapshot2.zip

THIS IS STILL A TEST RELEASE MEANT FOR TESTING AND NOT FOR PRODUCTION SITES

What it is
A snapshot of the current CVS, based on 2.2.2 with many changes and fixes from 2.2.3 and some additional ones after feedback from the first snapshot release.

How it should be tested
We have worked very hard on the references used throughout the code and would appreciate it, if you could test it on as many platforms as possible, especially:
- PHP 4.3.11 or lower (at least 4.2.0, though)
- PHP 4.4
- PHP 5.0.x and
- PHP 5.1

Preferably also on IIS as well as Apache.

Install from scratch and update from 2.2.x or 2.0.x following the upgrade instructions as per the last releases (2.2.x upgrade = update System Module, 2.0.x upgrade = run xoopsupdate.php and update modules individually)

XOOPS 2.2.3RC2 Snapshot2 requires a FULL URL set as XOOPS_URL - if you use a relative URL, modify your mainfile.php to be absolute (with http:// etc.) before testing

Also, have PHP debug and MySQL debug enabled throughout testing

THIS IS STILL A TEST RELEASE MEANT FOR TESTING AND NOT FOR PRODUCTION SITES

What in particular should be tested
- User creation admin (ext. profile module)
- User deletion admin (ext. profile module)
- Adding user fields (ext. profile module)
- Removing user fields (ext. profile module)
- Searching for users by values of added fields (ext. profile module)
- Send PM (PM module)
- Receive PM (PM module)
- Register user (ext. profile module)
- Send activation email (ext. profile module)
- Activate user from activation email (ext. profile module)
- Delete user account frontside (ext. profile module)
- Add/Edit blocks individually (System -> blocks -> add/edit)
- Edit block visibility and positioning in mass (System -> blocks)
- Add user to group in user edit (ext. profile module)
- Remove user from group in user edit (ext. profile module)

But mainly, we just want to make sure that any obvious mistakes are ruled out

When testing should be done
The sooner, the better, but if there are no major problems, we will release a public XOOPS 2.2.3 RC2 on Sunday.

Modules that should work in this version
Some modules that didn't work with 2.2.2- should work with XOOPS 2.2.3RC2 Snapshot:
- WF and -based modules such as WF-XXX, SmartXXX, PD-XXX should no longer have problems due to hidden fields overwriting select elements (add/edit categories, mainly)

Modules that won't work with this version
Modules that access users table directly, such as Newbb and CBB 1.x

GIJOE's blocksadmin plugin for 2.0.x does not work with 2.2.x so please focus on the rest of the module

Modules that directly use core files that have moved or rely on core behaviour that has changed, such as piCal

How reporting should go
Please use the SF.net bug trackers for your bug reports. Use the "core/core" or "core/install-upgrade" category and the "Xoops 2.2.x" group.

What else?
THANK YOU - everyone that participates in this testing.

THIS IS STILL A TEST RELEASE MEANT FOR TESTING AND NOT FOR PRODUCTION SITES
"When you can flatten entire cities at a whim, a tendency towards quiet reflection and seeing-things-from-the-other-fellow's-point-of-view is seldom necessary."

Cusix Software

2
JMorris
Re: 2nd XOOPS 2.2.3 RC2 Snapshot Release
  • 2005/10/6 17:34

  • JMorris

  • XOOPS is my life!

  • Posts: 2722

  • Since: 2004/4/11


Great! I'll start testing this evening.

Best Regards,

James
Insanity can be defined as "doing the same thing over and over and expecting different results."

Stupidity is not a crime. Therefore, you are free to go.

3
Briese
Re: 2nd XOOPS 2.2.3 RC2 Snapshot Release
  • 2005/10/6 20:21

  • Briese

  • Just popping in

  • Posts: 39

  • Since: 2002/1/3 1


"gzip" bug is still present!

( PHP Debug -> Off and gzip -> On )

PHP 4.4.0 and PHP 5.0.4

4
loukaum
Re: 2nd XOOPS 2.2.3 RC2 Snapshot Release
  • 2005/10/6 20:30

  • loukaum

  • Just popping in

  • Posts: 93

  • Since: 2003/11/2


Well done! I will just start testing here! Many thanks for this release!

Best regards!
Resized Image

5
smdcom
Re: 2nd XOOPS 2.2.3 RC2 Snapshot Release

Ok Mith! I'll try to find time to test this 2nd RC2.

6
JMorris
Re: 2nd XOOPS 2.2.3 RC2 Snapshot Release
  • 2005/10/8 14:15

  • JMorris

  • XOOPS is my life!

  • Posts: 2722

  • Since: 2004/4/11


I'm updating the beta1.xoops.org testing sites now. Everything should be ready to go in an hour or so.

Best Regards,

James

UPDATE: The beta testing sites are ready.
Insanity can be defined as "doing the same thing over and over and expecting different results."

Stupidity is not a crime. Therefore, you are free to go.

7
--Psy
Re: 2nd XOOPS 2.2.3 RC2 Snapshot Release
  • 2005/10/8 20:55

  • --Psy

  • Just popping in

  • Posts: 28

  • Since: 2005/8/2 2


Compared to this report:
https://xoops.org/modules/newbb/viewtopic.php?topic_id=41866&forum=39&post_id=183442

The notification system is active by default now, and the default method reverts to "email" if you don't install the private message module (good thing). But still I can't see the usual notification area on the bottom of the page until I assing it as a block. Is that the intended method? Because this way I get some problems against some module blocks.
Graphical glitch for IE users is still there.

8
JMorris
Re: 2nd XOOPS 2.2.3 RC2 Snapshot Release
  • 2005/10/9 3:27

  • JMorris

  • XOOPS is my life!

  • Posts: 2722

  • Since: 2004/4/11


Can someone please confirm the following?

- Searching for users by values of added fields (ext. profile module) Failed

4 users: Admin, test, test1, and test2
All 3 test users are active
test2 user was created as "Disabled" then set to Active prior to search test
test1 user was created as "Inactive" then set to Active prior to search test
Identical info except 1 and 2 is added on the second two users
All fields propogated with test, or test1, or test2 with respect to user
Same results as admin and as registered user

Search Query
============
Username: tes
Displayname: tes
Real Name: tes
Email: tes

Results
=======
test test@test.com
test1 test1@test1.com


Smarty Debug: -Not Applicable-
PHP Debug: -None-
MySQL Debug (Post Query): (see below)
Queries core
SELECT 
FROM ky33FH_config WHERE (conf_modid '1' AND conf_catid '1'ORDER BY conf_order ASC
SELECT sess_data FROM ky33FH_session WHERE sess_id 
'0191ceff7b9abc8d47cdd2579d2f50d6'
0.000433)
SELECT FROM ky33FH_users uky33FH_user_profile p WHERE u.uid p.profileid AND uid '1' LIMIT 01
0.000161)
SELECT FROM ky33FH_modules WHERE dirname 'profile'
0.000147)
SELECT FROM ky33FH_config WHERE (conf_modid '3'ORDER BY conf_order ASC
0.000168)
SELECT COUNT(*) FROM ky33FH_banner
0.000147)
SELECT FROM ky33FH_banner LIMIT 11
0.000235)
UPDATE ky33FH_banner SET impmade impmade+1 WHERE bid 2
0.000263)
SELECT FROM ky33FH_config WHERE (conf_modid '1' AND conf_catid '3'ORDER BY conf_order ASC
0.000113)
SELECT FROM ky33FH_group_permission WHERE (gperm_modid '1' AND gperm_name 'block_read' AND gperm_groupid IN (1,2))
0.000148)
SELECT DISTINCT i.instanceidb.*, i.* FROM ky33FH_block_instance iky33FH_newblocks bky33FH_block_module_link m WHERE m.block_id=i.instanceid AND i.instanceid IN (1,2,3) AND i.visible=AND i.bid=b.bid AND b.isactive=AND ( (m.module_id=AND m.pageid=0) OR (m.module_id=AND m.pageid IN (0,3)) ) ORDER BY i.weight,i.instanceid
0.000146)
SELECT FROM ky33FH_tplfile WHERE (tpl_tplset 'default' AND tpl_file 'profile_results.html'ORDER BY tpl_refid
0.000128)
Total Number of Queries12  |  Total SQL Generation Time0.002089

Queries module
SELECT 
FROM ky33FH_group_permission WHERE (gperm_modid '3' AND gperm_name 'profile_search' AND gperm_groupid IN (1,2))
0.000251)
SELECT FROM ky33FH_users uky33FH_user_profile p WHERE u.uid p.profileid AND (level '0' AND u.uname LIKE 'tes%' AND u.name LIKE 'tes%' AND u.email LIKE 'tes%' AND p.user_viewemail '1'LIMIT 020
0.000402)
SELECT COUNT(*) FROM ky33FH_users uky33FH_user_profile p WHERE u.uid p.profileid AND (level '0' AND u.uname LIKE 'tes%' AND u.name LIKE 'tes%' AND u.email LIKE 'tes%' AND p.user_viewemail '1')
8.4E-05)
Total Number of Queries3  |  Total SQL Generation Time0.000737

Queries block
SELECT 
FROM ky33FH_modules WHERE dirname 'pm'
0.000133)
SELECT COUNT(*) FROM ky33FH_priv_msgs WHERE (read_msg '0' AND to_userid '1')
7.8E-05)
SELECT FROM ky33FH_tplfile WHERE (tpl_tplset 'default' AND tpl_file 'system_block_user.html'ORDER BY tpl_refid
0.000116)
SELECT FROM ky33FH_modules WHERE (hasmain '1' AND isactive '1' AND weight '0'ORDER BY weight ASC
0.000118)
SELECT FROM ky33FH_group_permission WHERE (gperm_modid '1' AND gperm_name 'module_read' AND gperm_groupid IN (1,2))
0.000103)
SELECT FROM ky33FH_tplfile WHERE (tpl_tplset 'default' AND tpl_file 'system_block_mainmenu.html'ORDER BY tpl_refid
0.000132)
Total Number of Queries6  |  Total SQL Generation Time0.00068

Blocks
User Menu
: (3 QueriesNo Cache
Main Menu
: (3 QueriesNo Cache
Total
2 blocks

Execution Time
XOOPS took 0.13387799263 seconds to load
.

Extra


Environment:
XOOPS Version:
XOOPS 2.2.2

XOOPS Theme
:
default

XOOPS Template Set:
default

PHP Version:
4.3.11

MySQL Version
:
4.0.25-standard

Server Software
:
Apache/1.3.33 (Unixmod_auth_passthrough/1.8 mod_log_bytes/1.2 mod_bwlimited/1.4 FrontPage/5.0.2.2635 mod_ssl/2.8.22 OpenSSL/0.9.7a PHP-CGI/0.1b

User
's Browser:
Mozilla/5.0 (Windows; U; Windows NT 5.2; en-US; rv:1.7.12) Gecko/20050915 Firefox/1.0.7


Also, you'll notice in the above environment info that echo XOOPS_VERSION; is returning 2.2.2.

Thank you,

James
Insanity can be defined as "doing the same thing over and over and expecting different results."

Stupidity is not a crime. Therefore, you are free to go.

9
ToxicShady
Re: 2nd XOOPS 2.2.3 RC2 Snapshot Release
  • 2005/10/11 3:22

  • ToxicShady

  • Just popping in

  • Posts: 2

  • Since: 2005/4/12


Quote:

Briese wrote:
"gzip" bug is still present!

( PHP Debug -> Off and gzip -> On )

PHP 4.4.0 and PHP 5.0.4


I have had this bug since the original 2.2.3 release. glad I am not the onlyone who gets the blank page of death lol

I run php 4.4.0 also

Login

Who's Online

156 user(s) are online (99 user(s) are browsing Support Forums)


Members: 0


Guests: 156


more...

Donat-O-Meter

Stats
Goal: $100.00
Due Date: Mar 31
Gross Amount: $0.00
Net Balance: $0.00
Left to go: $100.00
Make donations with PayPal!

Latest GitHub Commits